吐温80与氢氧化钠耦合强化剩余污泥溶胞效果的研究

利用吐温80的润湿、渗透作用,将其与氢氧化钠耦合应用于剩余污泥的溶胞。结果表明,吐温80的存在能有效提高氢氧化钠对剩余污泥的溶胞效果;而同样的溶胞效果下,吐温80的存在能降低溶胞的环境温度。吐温80与氢氧化钠耦合剩余污泥溶胞工艺的最佳工艺条件为：吐温80投加量100 mg/L、作用时间15 min,先加吐温80再加氢氧...     

不同载体对淀粉酶固定化的比较研究

采用海藻酸钠微胶囊法和壳聚糖交联法对淀粉酶进行固定化，比较两种淀粉酶固定化方法的优劣。结果表明，两种固定化酶的活力回收分别为33．2％、26．6％，比活力分别为27．1U／mg蛋白、24．2U／mg蛋白，最适pH分别为5．0、8．0。海藻酸钠微胶囊法热稳定性、pH稳定性、操作稳定性、贮存稳定性明显高于壳聚糖交联法，因此海藻酸钠微胶囊法较佳，具有一定应用价值。     

The structure of the fire fighting foam surfactant Forafac®1157 and its biological and photolytic transformation products

For several decades, perfluorooctane sulfonate (PFOS) has widely been used as a fluorinated surfactant in aqueous film forming foams used as hydrocarbon fuel fire extinguishers. Due to concerns regarding its environmental persistence and toxicological effects, PFOS has recently been replaced by novel fluorinated surfactants such as Forafac®1157, developed by the DuPont company. The major component of Forafac®1157 is a 6:2 fluorotelomer sulfonamide alkylbetaine (6:2 FTAB), and a link between the trade name and the exact chemical structure is presented here to the scientific community for the first time. In the present work, the structure of the 6:2 FTAB was elucidated by ¹H, ¹³C and ¹⁹F nuclear magnetic resonance spectroscopy and high-resolution mass spectrometry. Moreover, its major metabolites from blue mussel (Mytilus edulis) and turbot (Scophthalmus maximus) and its photolytic transformation products were identified. Contrary to what has earlier been observed for PFOS, the 6:2 FTAB was extensively metabolized by blue mussel and turbot exposed to Forafac®1157. The major metabolite was a deacetylated betaine species, from which mono- and di-demethylated metabolites also were formed. Another abundant metabolite was the 6:2 fluorotelomer sulfonamide. In another experiment, Forafac®1157 was subjected to UV-light induced photolysis. The experimental conditions aimed to simulate Arctic conditions and the deacetylated species was again the primary transformation product of 6:2 FTAB. A 6:2 fluorotelomer sulfonamide was also formed along with a non-identified transformation product. The environmental presence of most of the metabolites and transformation products was qualitatively demonstrated by analysis of soil samples taken in close proximity to an airport fire training facility.     

Fe3O4纳米磁性微粒对全氟辛烷磺酸盐的吸附

采用共沉淀法合成Fe3O4纳米磁性颗粒,用透射电子显微镜(TEM)、X射线衍射仪(XRD)以及振动样品磁强计(VSM)对Fe3O4纳米磁性颗粒的粒径、形貌和磁性进行表征并研究Fe3O4纳米磁性微粒对全氟辛磺酸盐的吸附。结果表明:在PFOS初始浓度4 mg/L,pH为3,反应时间24 h,Fe3O4纳米磁性微粒投加量1.25 g/L,对全氟辛磺酸盐去除率达到90%。Fe3O4纳米磁性微粒对PFOS的吸附符合Freundlich吸附方程。     

旋转填料床/柠檬酸盐法吸收-解吸SO2

提出采用旋转填料床结合柠檬酸盐法脱除烟气中SO2的方法,考察了旋转填料床转子转速、液气比、初始柠檬酸根浓度和初始pH值等因素对脱硫效率的影响。结果表明,采用超重力法超重机转子转速为1 000 r/min、液气比为7L/m3、初始柠檬酸根浓度为1.5 mol/L、吸收液的初始pH值为5.0,脱硫效率稳定在99%左右。研究了水蒸气汽提法解吸SO2时初始柠檬酸根浓度、初始pH值、SO2浓度、富液流量和水蒸气流量对解吸效率的影响,得出了影响SO2解吸率的基本规律,并进行了分析。通过实验证明该方法在技术上是可行的,具有良好的应用前景。     

厌氧-好氧接触氧化处理汽车脱脂废水研究

采用厌氧UASB-好氧接触氧化工艺对汽车脱脂废水进行连续处理实验研究。结果表明,在脱脂废水进水COD浓度为6 000 mg/L,厌氧水力停留时间为3.4 d,好氧水力停留时间为2.5 d条件下,COD总去除率平均为93%,厌氧段平均值为38%。厌氧段可以提高出水的可生化性,厌氧-好氧接触氧化工艺效果要明显优于好氧工艺。     

次氯酸钠氧化脱除黄磷尾气中的硫、磷杂质

采用次氯酸钠氧化工艺净化黄磷尾气，在次氯酸钠溶液中有效氯的质量分数为0．65％，PH为9、反应温度为285K，气体流速为0．6-0.8L/min的条件下，对尾气中H2S、PH3的脱除率分别达到99．9％，和99．8％，出口含量分别小于0.2mg/m^3和7mg/m^3，对有机硫也有30％的脱除能力。     

氯化法处理医院废水的研究

介绍了次氯酸钠法和液氯法2种目前常用的处理医院废水的方法.对2家医院的废水处理过程进行了测试及实验研究.结果表明,这2家医院的废水处理后细菌总数和余氯量未达到国家规定的排放标准.主要原因是加氯量不精确,加氯后的停留时间不足,不能有效杀死废水中的病菌.对加氯量和停留时间的实验研究表明,每吨医院废水中次氯酸钠和液氯的最佳投入量分别为90 g和9 g,加氯后的停留时间不少于60min.     

用改性海泡石处理含磷废水

以海泡石为原料,经盐酸活化、水热活化,再加入氯化镁、氯化铁复合制得除磷剂原粉;再用聚氯乙烯将除磷剂原粉黏合成粒状除磷剂。用粒状除磷剂对废水中的磷（PO4^3-）进行吸附、洗脱,考察除磷剂的循环使用性能。实验结果表明：除磷剂对废水中磷的吸附容量可达92m g/g以上;以碳酸钠为洗脱剂,磷的洗脱率可达90%以上;除磷剂可重复使用,且性能优良。     

用造纸污泥制备改性木质素磺酸钠

以甲醛作改性剂，用造纸污泥制备改性木质素磺酸钠，通过正交实验考察了各种因素对改性木质素磺酸钠减水性能的影响。实验结果表明：木质素磺酸钠进行羟甲基化反应时，在10g粗品木质素中加入甲醛7mL、反应温度为45℃、反应液pH为10—11的最佳条件下，改性木质素磺酸钠的减水率为25．2％。经测试，改性木质素磺酸钠的各项性能指标均达到普通减水剂的国家标准要求。